cancel
Showing results for 
Search instead for 
Did you mean: 

ST-Link/V2 by IAR IDE in STSPIN32f0: "fatal error no MCU find"

supad
Associate

when we debug and compile in ST-Link/V2 by IAR IDE in STSPIN32f0 then this shows a problen that fatal error no MCU find. so what should be do for remove this error

  •  

1 REPLY 1
Imen.D
ST Employee

Hello @supad​ ,

I recommend you to upgrade firmware version using STM32 ST-LINK Utility: go to ST-LINK>firmware update. Then, disconnect and connect your board.

And check the jumper position.

With Regards,

Imen

When your question is answered, please close this topic by clicking "Accept as Solution".
Thanks
Imen