Posted on May 11, 2015 at 15:36Hi Hui,
I suggest to download the latest version of DK 1.7.0, anyway you have to add the following code:
-> in the file bluenrg_aci_const.h:
#define OCF_HAL_LE_TX_TEST_PACKET_NUMBER 0x0014
typedef __packed struct _hal_le_tx_test_packet_number_rp{
uint8_t status;
uint32_t number_of_packets;
} PACKED hal_le_tx_test_packet_number_rp;
- in the file bluenrg_hal_aci.c
tBleStatus aci_hal_le_tx_test_packet_number(uint32_t *number_of_packets)
{
struct hci_request rq;
hal_le_tx_test_packet_number_rp resp;
Osal_MemSet(&rq, 0, sizeof(rq));
rq.ogf = OGF_VENDOR_CMD;
rq.ocf = OCF_HAL_LE_TX_TEST_PACKET_NUMBER;
rq.rparam = &resp;
rq.rlen = sizeof(resp);
if (hci_send_req(&rq, FALSE) < 0)
return BLE_STATUS_TIMEOUT;
if (resp.status) {
return resp.status;
}
*number_of_packets = btohl(resp.number_of_packets);
return 0;
}
-> in the file bluenrg_hal_aci.h:
/**
* @brief This command returns the number of packets sent in Direct Test Mode.
* @note When the Direct TX test is started, a 32-bit counter is used to count how many packets
* have been transmitted. This command can be used to check how many packets have been sent
* during the Direct TX test.\n
* The counter starts from 0 and counts upwards. The counter can wrap and start from 0 again.
* The counter is not cleared until the next Direct TX test starts.
* @param[out] number_of_packets Number of packets sent during the last Direct TX test.
* @return Value indicating success or error code.
*/
tBleStatus aci_hal_le_tx_test_packet_number(uint32_t *number_of_packets);
Regards,
GM
In AN4494, Bring up BlueNRG app note, both Chapter 8 and 9 mention that
Send a further command to determine the number of packets sent by the Tx board: HAL_LE_TX_TEST_PACKET_NUMBER
What is the LE command above? Where can I find relevant code for it? I need it to get the actual number of TX packet sent for board RF tuning. I have code from DK1.6.0 for
HCI_LE_TRANSMITTER_TEST,
and
HCI_LE_TEST_END .
Thanks!
Hui
