cancel
Showing results for 
Search instead for 
Did you mean: 

BSL Problem 2

tflynn
Associate II
Posted on May 03, 2006 at 11:19

BSL Problem 2

2 REPLIES 2
tflynn
Associate II
Posted on May 02, 2006 at 17:25

Hello,

I am trying to bring up a new board (ST10F269). With a scope I can see the reset in asserting low and P0L.4 asserted low. I can see the serial character (NULL) coming in on the RX line.

The problem is that the TX line doesn't send out the 0xD5 character.

The TX just sits at gnd.

Any ideas on where to start?

tflynn
Associate II
Posted on May 03, 2006 at 11:19

I found the problem.

I have a Xilinx part that was driving the bus at reset. It drove the P0L.1 to low. The ST10F269 documentation is very thin on information about this mode.