St10 boot loader _ Read and write flash Procedure

newsamo · ‎2007-10-15

Posted on October 16, 2007 at 06:54

newsamo · ‎2007-10-15

Posted on October 15, 2007 at 11:02

Can anyone tell me protocol to read write flash of st10f 168 or st10f275 via serial interface (asc)

najoua · ‎2007-10-15

Posted on October 15, 2007 at 12:32

Hello newsamo,

You can use the ST10Flasher free tool provided by ST.

It is available on the following link:

at the bottom of the web page.

Best regards,

Najoua.

newsamo · ‎2007-10-15

Posted on October 16, 2007 at 06:08

I like to write a myown tool....

[ This message was edited by: newsamo on 16-10-2007 09:39 ]

newsamo · ‎2007-10-15

Posted on October 16, 2007 at 06:09

Does exists protcol in document?

[ This message was edited by: newsamo on 16-10-2007 09:40 ]

najoua · ‎2007-10-15

Posted on October 16, 2007 at 06:54

Hello newsamo,

This can be done by using the on chip bootstrap.

Please refer to the following discussion forum:

I hope this helps you,

Please let me know if you have further questions.

Best regards,

Najoua.