How to reset MCU through SWIM and command line

senayati · ‎2010-04-21

Posted on April 22, 2010 at 01:34

senayati · ‎2011-05-17

Posted on May 17, 2011 at 15:08

Stefan,

Thank you for your reply. The solution you offered worked fine and it is just what I wanted. Thanks again

Regards,

Sia Enayati

sramsauer9 · ‎2011-05-17

Posted on May 17, 2011 at 15:08

You can use gdb7.exe to restart mcu after programming.

I use the following command line:

gdb7.exe --quiet --command=restart_mcu.ini

Content of restart_mcu.ini

<-----------schnipp------------->

#

# define emulator reset port and MCU

#

define emulator-reset-port-mcu

target gdi -dll swim\stm_swim.dll -stlink3 -port $arg0 -mcuname $arg1

mcuname -set $arg1

end

#

# reset command and quit

#

emulator-reset-port-mcu usb://usb stm8s105c6

quit

<-----------schnapp------------->

You have to replace the mcu type (here stm8s105c6) to the one you are using.

Regards,

Stefan