cancel
Showing results for 
Search instead for 
Did you mean: 

Microcontroller get heated too much after connecting Battery voltage for RTC

lakshmikantha85
Associate II
Posted on February 03, 2011 at 17:19

Microcontroller get heated too much after connecting Battery voltage for RTC

1 REPLY 1
Posted on May 17, 2011 at 14:23

You must have a shorted pin/ball, the RTC VBAT should be pulling uA's (ie close to a million less than you suggest) by itself. It's getting hot because there is a problem, to the point you may well have damaged the part.

Try connection only to the VBAT, use something like a BAV70T to split between the primary and backup supply.

You might want to xray/inspect how your part is attached/soldered, reevaluate your circuit, and replace the current part, as the amount of current you are describing has almost certainly destroyed the part, or some portions of it.

Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..