Posted on July 17, 2017 at 19:04Hi all,
Following the schematics for the
http://www.st.com/content/st_com/en/products/ecosystems/stm32-open-development-environment/stm32-nucleo-expansion-boards/stm32-ode-connect-hw/x-nucleo-idw01m1.html
and the schematics for the
http://www.st.com/content/st_com/en/products/evaluation-tools/solution-evaluation-tools/communication-and-connectivity-solution-eval-boards/steval-idw001v1.html
where the LEDs are connecting from the pins to ground. There is a new schematic (
http://www.st.com/content/st_com/en/products/evaluation-tools/solution-evaluation-tools/computer-and-peripherals-solution-eval-boards/steval-3dp001v1.html
) that I have just encountered that has these said LEDs are connecting to the pins from a 3.3V source. Which one of these schematics are correct?
I am having the issue where the LINK LED goes off after it makes a successful link. This does not seem to be correct and it would seem that the link LED should light up once a successful link occurs.
It would seem that the new schematic
(
STEVAL-3DP001V1)
has the LEDs correct.
Any insight into this issue would be greatly appreciated.
