How to use STM32F767ZI with Arduino IDE?

Rishabh Gupta · ‎2017-09-18

Posted on September 18, 2017 at 14:11

I want to use STM32F767ZI , does it provide arduino support for all 114GPIOs or only on few pins. If it does support all the GPIO for arduino then how could I use them?

Tesla DeLorean · ‎2017-09-18

Posted on September 18, 2017 at 15:13

The chip supports whatever software you load on to it.

For Arduino, suggest you go to a place where they are actually implementing and supporting it.

http://www.stm32duino.com/

Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..

Rishabh Gupta · ‎2017-09-19

Posted on September 19, 2017 at 12:11

How can I use Arduino IDE for ST32F767? Can you provide me some supporting documents or examples ?

AvaTar · ‎2017-09-19

Posted on September 19, 2017 at 12:27

I think your question is better asked on an Arduino forum.

The IDE enjoys very little appreciation and support here, and thus your request might not yield results.