cancel
Showing results for 
Search instead for 
Did you mean: 

STMFlashLoader with the STM32L462RE

Ed Watson
Associate
Posted on December 20, 2017 at 01:00

I'm trying to use the GUI demo STMFlashLoader with the STM32L462RE

I do to get past the initial bootloader 'detection',PID (h) 0462, BID (h) NA, Version 3.1. Then the next screen is blank, with a blank pull-down menu for device selection.

Seems like the Map file is not found

I did see the link to demo version STMFlashLoader Demo_V2.9.0RC4, no change

I also saw a comment about flow control, no change with a loop back.

Any thoughts?

#stmflashloader-with-the-stm32l462re
1 ACCEPTED SOLUTION

Accepted Solutions
Imen.D
ST Employee
Posted on December 20, 2017 at 17:32

Hello,

You can use

https://my.st.com/content/my_st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-programmers/stm32cubeprog.license%3d1513783228390.html

STM32CubeProgrammer software for programming STM32 products.

Best Regards

Imen

When your question is answered, please close this topic by clicking "Accept as Solution".
Thanks
Imen

View solution in original post

3 REPLIES 3
Posted on December 20, 2017 at 15:13

ST is very slow a releasing updated tools. Please up vote the parent (ie I have this problem too).

Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Imen.D
ST Employee
Posted on December 20, 2017 at 17:32

Hello,

You can use

https://my.st.com/content/my_st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-programmers/stm32cubeprog.license%3d1513783228390.html

STM32CubeProgrammer software for programming STM32 products.

Best Regards

Imen

When your question is answered, please close this topic by clicking "Accept as Solution".
Thanks
Imen
Posted on December 29, 2017 at 00:07

It does work via UART/bootloader thanks

Note there is a pull-down menu to select ST-LINK, UART, USB.  I just tested the UART using the MCU bootloader.

For ST-LINK I use the IDE.