How can I program the EVAL-IPFC01V1?

Giovanni Bassi · ‎2018-02-20

Posted on February 20, 2018 at 13:48

Yesterday I started to work with the EVAL-IPFC01V1.

Can I program the STNRGPF01 with the ST-LINK/V2 through the SWIM connector J2?

Or I must use the UART J3 with the adapter in the box? In this case what is the correct FTDI cable model?

Best regards

#eval-ipfc01v1 #stnrgpf01

Carmelo VICCICA · ‎2018-02-20

Posted on February 20, 2018 at 14:34

Dear Mr Giovanni,

Thank you for your interest on ST products.

In blog post (

) explains in detail how to proceed for uploading the firmware generated by eDesignSuite within the STNRGPF01 device.

About the FDTI cable, it's recommended to use the following item:

TTL-232R-3V3

USB to TTL Serial cable (3.3V)

(i.e

)

About the possibility to re-insert the custom firmware for 'EVAL-IPFC01V1' in the next days I hope to

publish

a new post blog about this issue.

Best Regards

Carmelo

Giovanni Bassi · ‎2018-02-20

Posted on February 20, 2018 at 15:05

OK.

I'll try it in the next days.

Best Regards

Giovanni

TBiel · ‎2018-12-14

I posted a topic where I described how to reprogram a STNRGPF01...

Not trivial but easy to do