Setting LIS2MDL Interrupt Threshold

Nishant Garg · ‎2018-06-25

Posted on June 26, 2018 at 00:26

Hi,

I am trying to dynamically configure the interrupt threshold on the LIS2MDL. It seems that sometimes after setting a new threshold, the old threshold still is in effect and causes an interrupt transition on the output pin. Is there any minimum (settling) time required after setting a new threshold on the LIS2MDL?

Thank you.

Nishant Garg · ‎2018-07-04

Posted on July 04, 2018 at 20:02

Hi - Update to all. I have determined it was an issue with my code. The updated settings do seem to be taking hold correctly/immediately.

View solution in original post

Tesla DeLorean · ‎2018-06-25

Posted on June 26, 2018 at 02:46

Do the settings and new measurements read-back properly?

Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..

Nishant Garg · ‎2018-07-02

Posted on July 02, 2018 at 22:08

Yes the new settings read back from the registers immediately

Nishant Garg · ‎2018-07-04

Posted on July 04, 2018 at 20:02

Hi - Update to all. I have determined it was an issue with my code. The updated settings do seem to be taking hold correctly/immediately.