Posted on July 16, 2018 at 11:25Hello,
I am trying to update from firmware 2.6 to 3.7 (following the document
https://github.com/USIWP1Module/USI_I-NUCLEO-LRWAN1/blob/master/preloaded_firmware/WM-SG-SM-42%20Update%20Preloaded%20AT%20Command%20FW%20Application%20Note%20rev.%201.4.pdf
) , but whatever I try, I get this :
PS D:\sm42_fw_update_tool_v1.1-1\bin> .\sm42_backup.bat 6
'0) stlink-v1'
'1) stlink_v2'
'2) stlink_v2-1'
select a profile no. from above? 0
going to run using 'stlink-v1'
Open On-Chip Debugger 0.9.0-dev-v1.2 (2017-02-27-12:14)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Error: sm42 interface seems abnormal ...
PS D:\sm42_fw_update_tool_v1.1-1\bin> .\sm42_backup.bat 6
'0) stlink-v1'
'1) stlink_v2'
'2) stlink_v2-1'
select a profile no. from above? 1
going to run using 'stlink_v2'
Open On-Chip Debugger 0.9.0-dev-v1.2 (2017-02-27-12:14)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Error: sm42 interface seems abnormal ...
PS D:\sm42_fw_update_tool_v1.1-1\bin> .\sm42_backup.bat 6
'0) stlink-v1'
'1) stlink_v2'
'2) stlink_v2-1'
select a profile no. from above? 2
going to run using 'stlink_v2-1'
Open On-Chip Debugger 0.9.0-dev-v1.2 (2017-02-27-12:14)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Error: sm42 interface seems abnormal ...
I uninstalled every driver and installed their newer version, ST-Link utility is up to date, the st-link driver is up to date. When trying to access the STM32L0 on the board via ST-Link, it works fine :
11:08:39 : ST-LINK SN : 52FF71066765565248570467
11:08:39 : ST-LINK Firmware version : V2J29S7
11:08:39 : Connected via SWD.
11:08:39 : SWD Frequency = 4,0 MHz.
11:08:39 : Connection mode : Connect Under Reset.
11:08:39 : Debug in Low Power mode enabled.
11:08:39 : Device ID:0x417
11:08:39 : Device flash Size : 64KBytes
11:08:39 : Device family :STM32L0xx 64k
ST-LINK detects the 3.7 hex as corrupted, I already downloaded it multiple times and it did not change.
If you have any ideas as to why I can't update the firmware that'll be of great help
#i-nucleo-lrwan1
