FAQ: SPC5Studio IDE - Enabling interrupt using Wizard

Document created by Online Support Moderator on Dec 11, 2016Last modified by Online Support Moderator on Dec 26, 2016
Version 3Show Document
  • View in full screen mode

Q:
I am using SPC5 Studio V5.0.0. I would like to know how to configure interrupts using Wizard?
Is there any user manual to configure GPIO, Memory, Interrupt and generate code using Wizard?

 

A:
You can find the help documents below: Click the Help Content of Help Menu.

SPC5Studio - Help

 

You can get information on how to generate code, how the configure the PIN in PinMap wizard.

SPC5Studio - IRQ


Regarding the interrupt configuration, you can get start from the IRQ demos through the SPC5 Studio application wizard.

SPC5Studio - Application Wizard

1 person found this helpful

Attachments

    Outcomes